Your search for "M1D" returned the following:


Replacement Parts

MTG-1D

Top Grid

Compatibility

  • M1D
  • M1D-Sub

Part #: 40.115.110.01

The MTG-1D provides multiple hanging configurations for M1D and M1D-Sub arrays. MTG-1D provides for single- or multi-point support and bridles. An adjustable rear extension frame provides flexibility to keep the point load equal. Up to 16 M1Ds (or the equivalent weight of M1D and M1D-Subs) may be suspended from single or multiple rigging points of appropriate rating.

MG-1D

Multipurpose Grid

Compatibility

  • M1D
  • M1D-Sub
  • M2D
  • DF-4
  • UPA-1P
  • UPA-2P
  • MSL-4
  • DS-4P

Part #: 40.115.100.01

The versatile MG-1D multipurpose grid allows M1D/M1D-Sub loudspeakers to be flown or ground stacked. MG-1D also provides a transition from the bottom of an M2D/M2D-Sub array to an M1D/M1D-Sub array. Up to 16 M1Ds (or the equivalent weight of M1Ds and M1D-Subs) may be suspended from single or multiple rigging points of appropriate rating. In addition the MD-1D can be used to fly M2Ds and/or M2D-Subs. Up to seven M2Ds (or the equivalent weight of any combination of M2Ds and M2D-Subs) can be flown from the MG-1D grid at a 7:1 safety factor, or 10 M2Ds at a 5:1 safety factor.

MUB-1D

Mounting U-Bracket

Compatibility

  • M1D

Part #: 40.115.021.01

Supports or suspends multiple M1Ds in a floor or ceiling mounted configuration. Numerous tilt angles are possible.

Important: Not rated for mounting more than (1) M1D if using only the center attachment hole. See further information on page 21 of the M1D Rigging Grid Assembly Guide. Not to be used with the M1D-Sub.

M1D-MUB

Mounting U-Bracket, M1D-SM

Compatibility

  • M1D

Part #: 40.115.045.01

The M1D-SM loudspeaker is a version of the M1D utracompact curvilinear array loudspeaker with alternate end plates for single-mount configurations with the M1D-MUB Ubracket.

Important: The M1D-SM end plates come standard with the unit and are factory-installed. The end plates are not available as an upgrade option for M1D loudspeakers.

MVP

Motor Vee Plate

Compatibility

  • LEO-M
  • LYON
  • MILO
  • MICA
  • M’elodie
  • MINA
  • M3D
  • M2D
  • M1D

Part #: 40.215.184.01

The Motor Vee Plate connects two motors to the either the front or rear rigging point of a top grid to provide rotation of the grid along its horizontal axis without tilting the array. Mounting holes will accommodate standard 5/8”, 3/4” or 7/8” shackles, size depending on the needed lift capacity.

Replacement Parts

PIN-QRP

Connecting Hardware

Compatibility

  • M1D
  • M1D-Sub
  • MG-1D
  • MTG-1D

Part #: 134.020

5/16" X 1.25" QRP button-head - Used in all M1D rigging holes